After a deal of success with the command line interface-to-Arduino project, I am in the middle of stepping it up a notch. I ended up on a few blogs due to that last effort, which indicates that I am doing something worthy of note. Hats off to me, perhaps. Well, my tool belt is what it is…if I can’t do it via shell scripting, I reach next for Python. In an attempt to parse stuff that I have been ‘getting’ via wget, I found myself trying to do some clunky regex from the command line. Guess what…I can do that without as much heartache via Python via BeautifulSoup…
Thus far, I have python doing the website getting and Beautiful Soup doing the parsing of my site…basically just grabbing some info at this point that I can modify. I have my LCD driven via my trusty Arduino, and that is that. Instead of redirecting standard out to serial, I am writing to serial via python. Easy breezy.
I have some sloppy sloppy code at this point, and need to add some hardware and stuffs to my prototype. Stay tuned…this could be a good one.
t3st1ng p4rs1ng
LCD test
python
1234567890%%
t3st1ng p4rs1ng
LCD test
python
1234567890%%
test2
test2
a
a
a
aa
aa
asldfjasdfljasdfl;asdfjasd
test
asldfjasdfljasdfl;asdfjasd
test
test
test
testttttttttttttttttttttttt
testttttttttttttttttttttttt
try3
try3
try3
june 1 test parsing
june 1 test parsing
june 1 test parsing
new message test @30s
new message test @30s
new message test @30s
new comment
new comment
new comment
test check test check
it werkz yo
it werkz yo
gggg
gggg
swantron.com test
swantron.com test
awesome
awesome
comment here
comment here
dry run
swan tron dot com
swan tron dot com
+1 awesome
+1 awesome
swantron dot com
swantron dot com
thanks for tuning in
thanks for tuning in
thanks for tuning in
swantron.com FTW
here it is
here it is