Upgrading DC Motors to Servos

A whole bunch of Dremel work and some hot glue…

The Clocky conversion to servo motor control is mostly done.

clocky with servos
getting close

I still need to make the servo mounts more secure, but the initial test runs look promising:

Getting close. I determined that the IOIO board will not fit inside the casing, so I will have to come up with an external mount. Which will change the balance, so I might end up having to add some counterweights for balance. It should shape up, mechanically, in another garage session or two. The UI work will be another session, thereafter, but look for a finished product within the next week or so.

IOIODC Project Details

Consider this the conclusion of the IOIO DC motor experiment until further notice…

IOIO DC Motor Code
still ugly

I’m chalking this up as a success. Even though it is ugly and raw, I learned a ton mashing this thing together. Very fulfilling project from a nerd standpoint: I learned more Java, had to buckle down and do a little EE, kicked up the soldering skills a notch, and introduced a few more components’ features into my ghetto skill set.

My code is live on github with a preemptive v1.0 push…

IOIO DC Motor Code
IOIO DC Motor Code

I also dumped the apk to the Android Market as promised.

Pins 21 though 26, wired through the usual candidates on an H-Bridge. Contact me with any details…it should be very spec sheet-heavy though. The main stumbling point is with the power source, so keep that on the front burner.

Cheers. This may be my last time intensive project for some time. Hardware is time-costly…I am planning to take on the software project I have been contemplating between diaper changes and feedings. Look for some dad stuff in the mean time…